TV Repair: Common Faults and Solutions.
Search:
Results: 87427
Results: 87427
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | WMD6C | No record, right channel playback ok | No record, right channel playback was ok. waveform at bothhead leads showed virtually identical bias and audio waveforms. head waschanged. switched head wires. problem remained in same channel. finallykilled bias oscillator and looked at head input | ||
SONY | STRVX550 | No control of volume, bass, tremble and input switching | Volume was at one set level and would not change. displaywould change. also all inputs were being passed through the asp chip andswitching would not switch the asp chip. asp chip had been changed withno success. we had data circuit and strobe into ic | ||
SONY | D15 | (enter/remain) switch does not function | Enter/remain switch does not function. this problem has alsobeen verified in three other units with unrelated serial numbers. | ||
SONY | KV20XBR | Set inoperable | Set was inoperable, i.e., no b+ from power supply. locatedshort in 200v line caused by c-703. | ||
SONY | KPR41DS2 | Shutdown, replaced green crt | Unit would go into shutdown when turned on. sleep light wouldcome on. found green picture tube shorting. | ||
SONY | KV27HFR | Vertical instability and some horizontal flagging, c-520 | Unit had vertical instability with either antenna or ext video(vcr playback). with an external video generator the unit was fine.reducing the gain of the generator unit would again have instability.checking the signal at ic-301 pin 47 and 48 found the s | ||
SONY | STRAV450 | Smelled hot, smoked | Customer complained that the unit smelled hot. r-666 hadoverdissipated and caused a hole in the circuit board. cause unknown. | ||
SONY | KV27TX10 | Squeal, install reactorless yoke, see sb tvp0114 | Squeal sound. | ||
SONY | CCDV9 | No picture | No picture. | ||
SONY | CDPC40 | Non compatibility of some compact discs | Both models (cdp-c70 and cdp-c40) will not play track no. 1 onthe following warner bros./reprise cds:1. seals and crofts/greatest hits, wb3109-2 - sr005.2. gordon lightfoot/if you could read my mind, reprise 6392-2 -src01unit will play any other track on | ||
SONY | CDPC70 | Non campatibility of some compact discs | Both models (cdp-c70 and cdp-c40) will not play track no. 1 onthe following warner bros./reprise cds:1. seals and crofts/greatest hits, wb3109-2 - sr005.2. gordon lightfoot/if you could read my mind, reprise 6392-2 -src01unit will play any other track on | ||
SONY | KV27TX20 | Intermittent high pitch squeal, glue etc coil on yoke | Servicer states that out of the box set has intermittent high pitched squeal. he found that etc coil on dy yoke had broken loose from its glued down position. | ||
SONY | SLV70HF | Drum assembly | Need correct part number for slv-70hf. when you enter thecomputer part number h-5436-143-h shows this to be drum assembly slv-50. -hq comments: the part number is correct. the description on the com-puter has been corrected. | ||
SONY | KV25DXR | Unit was locked in service ready mode | Locked in service ready mode. | ||
SONY | SLHF450 | Unit shut down | Intermittently, unit would spill tape and shut off due toslack on tape. also serial number 21843. | ||
SONY | SLHF450 | Part no., pg. 127 of service manual (pc board retainer) | Need the part number for the plastic ring between the (r)board and the rotor assembly. -hq comments: the part number is 3-679-313-01. a service bulletin willbe issued shortly. | ||
SONY | PCM601ESD | Unit has no output | Unit had no output. press record mute and output heard.found no output from ic-511 pin 4 to (d) flip-flop ic-512. gain of q-529was down. | ||
SONY | CDP507ESD | Transit screw does not always lock | The sled assembly is not locked by the transit screw. | ||
SONY | KV27DS1 | Need sony badge p/n, 3-704-179-01 | Need part number for sony badge (name plate). -hq comments: the part number is 3-704-179-01. | ||
SONY | BCA80 | Relay chatters/charge led flashes | We have had several units at the ssc with an open f1. thesymptom displayed is an intermittent flashing of the charge led and relaychatter. the unit may appear to have a bad connection because touchingvarious parts of the board sets up oscillations. |