Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TC1444 | TV turns on and blinks along with the by LED | R713 atherated giving 176k | Replacing it as it is a r of 100k | ANDRE SOS |
PHILCO | PH32E31DG | League works shows right after with vertical lines | Oxidation and dirt on the flat cable on the right side of the screen | Clean the screen flat on the right side, clean the screen frame wsound the flet is located | klaudio |
PHILCO | TP1454 | TV doesn't turn on, LED lights up weakly | Directly replace the 2 elcos in the primary power supply c927 of 2.2 mf + c943 of 100 mf | Irmao | |
PHILCO | PH14B | Sometimes it turns on, sometimes it doesn't. the LED stays on. | Defective l752 coil. | marcones de Araripina Pe. | |
PHILCO | PH21M SS | +b oscillating and LED blinking. | Q 802 2n5551 and 18v diode shorted. the zener diode that is in the position of r 816, 12v line. | After the replace everything was ok. | George Pontes |
PHILCO | PH24M LCD | Triplicate image | Eeprom | Enter setup by typing menu 9735 then in config just replace the id and restart | beto2828 |
PHILCO | TP2920 | +b bass and cushion effect | Defective q905 | Q905 e so replace | GERISOM |
PHILCO | PCS2976S | Sound failing, time is, time is n. | Change sound output tda7499 | DJ PITUKA | |
PHILCO | TP-2052N | Led stand-by picando, +b variando. | C905 | Paulo lopes | |
PHILCO | TP 1453 | TV doesn't turn on LED when you press power LED turns off for 2 seconds, lights up and doesn't turn on | Flyback | Replace o flyback | novin |
PHILCO | PHT660N | Capacitor replacement | Capacitor e11 as low capacitance | Capacitor replaced | Ivanildo Soares |
PHILCO | PH21MG SS | TV doesn't turn on. LED flashes and comes on again. +b with 20v. After checking all capacitors in the vertical and horizontal circuit, they were all good. | The defect was the vertical output IC la78141 with a short between terminals 2 and 3. | Ci replaced and the TV returned to normal operation. Note: for testing you can use the tda9302h, but the correct option is to use the original la78141, as this IC works very hot. | Carlão |
PHILCO | TP1453 | Black and white image | Memory | Unplug the TV from the socket, hold down the menu + volume down keys simultaneously for 5 seconds, plug in the socket, release the keys and turn on the TV using the power key | Emerson |
PHILCO | PH32F33DG | Turns on, the logo appears and then turns off | A common defect in this model is one or more broken LEDs. | Before dismantling the panel, check the voltage in the three pairs of wire that go to the LED panel, it must be the same, if tsound is a difference, it is certain that tsound are shorted LEDs in the panel, which will trigger the protection and the TV will turn off. | Miratec Eletrônica |
PHILCO | PH22S31D | Red standby LED on, does not turn on. | Probable leak in one of the fets q3 or q5 on the main board. | Check the fets on the main board q3 and q5, on the collector pin of q3 tsound must be 12v to ground, on the collector pin of q5 tsound must be 5v to ground. | EC |
PHILCO | PB329BT | Sound disappears after a few minutes of switching on | Failure in the IC1 ET2314 function switching integrated circuit, tsound was no sign of abnormal heating | Replace IC1 ET2314 by PT2314 on 05/07/2018 | AVELS NOBREGA EXPHS |
PHILCO | PH51C20PSG | 5v voltage from stand by pulsing | Smd transistor q309, code 2x it is npn, a bc848 was placed in place working normally. | Replace q309 | Silnei |
PHILCO | PH51U20PSGW | 5v voltage from stand by pulsing | Smd transistor q309, code 2x it is npn, a bc848 was placed in place working normally. | Replace q309 | Silnei |
PHILCO | PH29B | The normal power supply relay hits and does not arm | Q401 | Replaced | ELTON CASTRO CABO-PE |
PHILCO | TP1453 | No audio | R-408 or r-409 in my case it was the open r-408 | Replace and that's it | ELETRÔNICA CAVALCANTE |