Search:
Results: 87413

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYKV1946R
Picture distortion, replaced c524Set would go into vertical bounce after warm-up.
SONYKV1945RS
Snow picture, replaced prescalerSnow on all channels. no output from prescaler.
SONYKV1945R
Sound and picture distortion, replaced ic005Volume and picture levels go down. one could adjust volumeand picture levels in up mode, but a few seconds later, the levels wouldgo down to minimum.
SONYKV1945R
Intermittent on/off, leaky d026Intermittent on/off. last channel memory is off. when turnmaster switch on, tv comes on intermittently. ic006 pin 11 is low (2.4v)should be 5.1v. d026 zener didoe was leaky.
SONYKV1913
Vcr pb picture distortionViewing tv normally, off channel no problem set looks good,however, when vcr played through set, top of picture would curve to rightlike flag waving. vhs system is what customer has and complained on.however, distributor put betamax through unit and sam
SONYKV1221R
No on/off function, replaced rl001Unit would not shut down manually or on remote. whenattempting to turn off set with manual switch or remote, the sound wouldmute, but the raster would remain. tapped on the case of relay rl001.power immediately went off. found rl001 was hanging up due
SONYKV1216
Picture pulling horizontally, replaced ic201Picture pulling horizontally on some channels. problemtraced to output of sync separator, q301, where horizontal sync amplitudewas lower than normal. observing composite video at pin 14 of ic201showed horizontal sync pulse to be just slightly higher th
SONYKP7220
Picture distortionSet had about 8 inch overscan. found set-up cord was18 inches too long.
SONYKP7220
Insufficient vert height, replaced c5521Insufficient vertical height on all three crts: about 3inches short top and bottom of the screen. found vertical sawtooth atbase of q5510 (on da board) reading 2.4vpp, should have read 3vpp.
SONYKV2647R
Retrace lines and raster pulsade, hairline crack on c boardRaster was pulsating at a steady rate about 3 times persecond, retrace lines were visible, excessive brightness and video fading.found a hairline crack on c board g2 line.
SONYKV2647R
Vertical foldover, c508Set has severe vertical foldover on top of screen.
SONYKV2645RS
No operation, replaced q203, d202 and r533No raster, no sound and channel indicator does not light up.
SONYKV2645R
No picture, replaced q006-8 and d012No reception on all channels. found no vc, no 12v at thetuner. all displays and addressing ok. found q006-8 transistors shortedand d012 defective.
SONYKV2645R
Dead, replaced c019Set would not turn on. found c019 shorted.
SONYKV2145R
No sound, broken lead on output transformerNo sound. inspection revealed broken wire from secondaryof sound output transformer to solder lug, right at the lug.
SONYKV2145R
No vhf, bt981 prescalerNo vhf low and high band, very intermittent.
SONYKV1945R
Incorrect tuning function, replaced ic004Only numbers 1 or 2 can be addressed on tv by hand unit.operation on channel selection manually is ok. i found pin 28 of ic004has 10vdc on it at all times. waveforms on pin 37 were normal but theamplitude of waveforms at pin 14 were very low with all n
SONYKV1914
No pictureUnit would blank out approx. after 1/2 hour, sound stillnormal. by turning set off for a while and turning it back on, the unitwould again work for a shorter period of time and blank out. found thatby freezing vertical output ic unit would function nor
SONYKV1546R
Set would not turn off, replaced rl001Set would not turn off when power switch pressed. brightnesslevel would drop but would not turn completely off - intermittent problem.
SONYKV1545RS
Short range remote operation, replaced d1Customer complained of short range, approx. 12 feet.