TV Repair: Common Faults and Solutions.
Search:
Results: 87413
Results: 87413
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | KV2602 | Vertical foldover, replaced ic502 | Vertical foldover at bottom. all voltages around ic501 andic502 checked good except pin 5 of ic502 which was very low, waveformswere distorted. | ||
SONY | KV2145R | No video/sound, replaced prescaler | No video - no sound. | ||
SONY | KV2145R | Dark picture, replaced brt control | Unit loses brightness (goes black) intermittently. voltageok, tp49 goes low whenever problem occurred. found brightness controlshorting to its case. | ||
SONY | KV1946R | Dead, fbt | Flyback arc over. | ||
SONY | KV1946R | Sound noise, replace t206 | This unit had a background hiss in the sound. adjusting t206 did no good. found t206 had the incorrect transformer installed.p/n 1-403-360-13 was marked on the outside. | ||
SONY | KV1913 | Shut down | At turn on, set would shut down after a few minutes to a fewhours. | ||
SONY | KV1913 | No sound | Sound goes on and off, cooling c226 would confirm problem. | ||
SONY | KV1746R | Shut down, installed c547 as per t/n | This unit would intermittently go into hv shutdown. | ||
SONY | KV2644R | Incorrect tuning, replaced ic2002 | Set would stay in address position a at all times. i foundwhen i turned channel set switch on and programmed set, it would work ok.but if i shut the set off, and turned it back on again, it would come onin position a and could not be addressed again. | ||
SONY | KV2643R | No operation, replaced c539, c805 and r812 | Set inoperative. found r812 open and c805 leaky. replacedthem and picture displayed vertical bar (approx. 5 inches) on left side,r812 was running warm. found c539 open. | ||
SONY | KV1945RS | Poor remote operation, replaced ic1, cx-786 in commander | Poor sensitivity with remote approx. 6 feet. | ||
SONY | KV1945RS | Shut down, selected r563 | This unit intermittently shuts off, sometimes twice a week,sometimes once. voltage on pin 12 was 5.3v making it too near thethreshold level of 5.6v, changing r563 to satisfy the procedure in manualresults in a 15k resistor which was half of the original | ||
SONY | KV1945R | No color, replaced ic501 | No color. found no pulse at pin 20 of ic301. traced theproblem to pin 22 of ic501 where i found no sync out. | ||
SONY | KV1217 | Dead, replaced q602 | No sound, no picture, channel indicator stays in one position,tuning and band indicators are dim. found regulator transistor q602leaky, and both audio output transistors q205 and q206 shorted also r232open. | ||
SONY | KV2647R | Snow picture, resolder r053 | Set displayed snow on all channels. i found r053 on mf boardimproperly soldered. | ||
SONY | KV2647R | Set would not turn on/off by remote, ic-101 | Set would not turn on/off. | ||
SONY | KV2645RS | Color distortion, replaced r751 | Bleeding color (red). found r751/470kΩ resistor changedvalue. | ||
SONY | KV2643R | Raster pulsating, replaced r609 | Picture and raster pulsating. the 135v line exhibited samepulsation. | ||
SONY | KV2145R | No picture, fbt | Set kept shorting out the horizontal output transistor. | ||
SONY | KV2101 | Picture distortion | Set had light vertical bands in picture. they started on the left and became less bright as you moved to the right. horizontal output waveform was affected as well. |