Search:
Results: 87413

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYKV1945R
No picture, c1008 in prescaler shorting to frameThe following notes were made in determining problem. 1) nowave train at pll in, tp59. 2) no voltage on pin 15, ic003. 3) voltageat tuning point on tuner went to 31.5v and would not vary. cause - c1008on prescaler was shorting to adjacent frame on p
SONYKV9300
Incorrect brightnessThe set has an excessive brightness. the screen control ishigh and cannot be adjusted, r706 is open.
SONYKV9300
Retrace linesRetrace lines, no screen control.
SONYKV2645R
Audio cracking, replaced t207Intermittent audio cracking.
SONYKV2643R
No soundNo sound, picture ok.
SONYKV2643R
Channel lock, replaced l001Right after turn-on, tuner would lock on a channel. wouldnot change channels manually or by hand unit. it had no clock on pins12 and 13 of ic001 (volume and on/off ok).
SONYKV1945R
Poor remote operation, resoldered x002 on md boardPoor response from remote control. poor range - missesfunctions.
SONYKV1945R
Poor remote operation, resoldered shield to n boardWeak remote range. this unit had poor shield ground on then board causing the short range of remote control.
SONYKV1913
No audio on ch 10-12No audio on channel 10/12 or very low sound. found channelind. lamp for channel 10/12 defective.
SONYKV1545R
Remote operation range too short, open ground "n" boardThis unit had poor shield ground on n board causing shortrange on remote when set was on.
SONYKV1221R
Picture distortion, replaced c524Picture pulled up 3 inches on bottom of the screen and upperright hand corner blanked. found c524 off pin 13 ic301 was installed withpolarity reversed.
SONYKP7220
Incorrect blue convergence, replaced d5320This unit had a blue convergence problem. the blue verticallines were wider than the red or green.
SONYKP7200
Incorrect tuning operationTv would scan but would not stop on stations.
SONYCFS45
Defective side platesPlastic handle side plates on this model brake. handle side plates may not be strong enough to carry weight of this model under allstress conditions.
SONYKV8000
Poor h syncSet displayed poor horizontal sync.
SONYKV1945R
Color distortion, replace ic301No blue, yellow picture. base voltage at q701 was 0 volts.output at pin 28 at ic301 0 volts, input to ic good.
SONYKV1913
No pictureLoss of vertical deflection.
SONYKV2643R
Shut down, removed l810This unit would shut down by itself. the picture wasexpanded in size (a lot of overscan). the hv was 3kv lower.
SONYKV2643R
Sound no mute during change, replaced q042Sound would not mute during channel change. checked pin #13of ic032 positive pulse was present during channel change, therefore,q042 was suspected.
SONYKV2643R
Clock display dims, replaced displayClock display dims when touched by hand. display flickers when someone walks by tv.