Philco TV Repair: Common Faults and Solutions.

Search: Philco
Results: 4740

Philco Repair Guide: Common Issues and Fixes

Brand	Model	Fault	Detailed Problem	Solution	By
PHILCO	PH21MSS	Liter at the top of the screen by doubling the image	Capacitor 307 de 100µf/35v	Replace the same	Cassiano
PHILCO	PH29USA2	LED lights up and slowly turns off	C406 100x25 sold out	Just replace	Paial.eletros
PHILCO	PH29USA2	Brightness oscillating as if it were flyback	C450 cracked	Just replace	Paial.eletros
PHILCO	PH29T21D 40-0MS09L	With sound, LCD access without image.	After checking the t,com bus voltages, tsound is 0 volts on the vaa test pin.	It was found after applying a small voltage with the asymmetric power supply on the Vaa pin that the capacitor in position cd19 was getting very hot, and after replacing it the TV returned the image normally.	IZAQUIAS S.BERNARDO-MA
PHILCO	PH32E20DSGW	Turns on, the LEDs flash and turns off	I tested it with an original kit on the outside and even though the LEDs blinked, it turned off and returned to stanby	24v and 12v power supply drops very little, almost imperceptibly: changing c2d3/c2d2 and c1d9, both 100μF/50v, in addition, the capacitor c1d2 was swollen, so I also replaced c1d2/c1d3/c1d4, both 470/25v.... it was just joy....	MIGUELTV
PHILCO	PH39N91	TV turns on normally, with sound but the image has interference and aliasing	Faulty capacitor cw 806	Replace capacitors	<small>Alex Lopes This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
PHILCO	PH39N91	Power supply with secondary shorted and does not work	Shorted cw 822 and cw 808 capacitors (smd capacitors)	Replace capacitors	Alex Lopes <small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
PHILCO	PH43E30DSGW	Burning the LEDs	Power supply	The burned out LEDs were replaced, and the black light resistors r403, r407, r411, r415, r419, r423 were retightened, the resistors were removed and the 63v power supply dropped to 61v, we no longer burned.	ELETRONICA JUNIOR BELEM PARA
PHILCO	TP2054	Generates discharge from the pacifier but does not break	Head of 6n8		Lopestv
PHILCO	PH51U20PSGW VER B	TV turns on, the logo appears and then turns off, remaining in stand by mode	Update. just that		GR Eletrônica
PHILCO	PH14D	Does not turn on display off	Res 819 intermittent defect	Replace resistor even though it measures good	Flavio FJLeletronica
PHILCO	PH21MSS	Burning vertical	Tall vertical power supplys	Transfomador driver	edval
PHILCO	PHT660N	No sound on all speakers	220x16v raw capacitor e27	Replace and practice for the hug	orlando lott
PHILCO	PH42F10DSGWA	The screen LED does not light up	Shorted capacitor smd cw21 and smd resistor rw48 near the		Celio Paulo de oliveira
PHILCO	PH21MSS	It doesn't turn on, it turns on, the power supply drops to 20v, it makes a noise like it's the flyback and the stanby LED keeps blinking	Change deflector.		DJ PITUKA
PHILCO	PH14D	Does not turn on +b 50 volts and the LED flashes quickly.	R881 of 10r in the open +b row.	After changing the TV ok.	George Pontes
PHILCO	PH29MSS 40-00NX56-MAP1XG	The protection works and does not turn on	Change the d810 that powers the vertical +14v	The TV when I turn it on it goes into protection I released the memory and promotions it turned on with the vertical closed then I saw that tsound was no power supply then I found the d10 open I replaced it all resolved	Eletronica smart
PHILCO	PHT660N	Connected the wrong network to 220v with the 110v switch	The primary transistor 13005 burned out, I replaced it, it had low voltage at the output, causing q2 and q3 2n5551 to open too	Replace the input transistors and q2 and q3 2n5551 sound's a tip, this transistor is problematic	beto2828
PHILCO	TPF2130	Turns on with excess brightness without adjusting in the dark	Replace resistor 707 4r7	R707 de 4r7	Daniel Mauriti CE
PHILCO	TP-1454	Does not turn on the LED is off and tsound are zero volts on the secondary.	Tsound is no power supply on the ic901.	Replace r909	Eletrônica Daniel Fone: 43-991586898